Home › M64×4
M64×4 — Full Fastener Spec
ISO 68-1 / ISO 261 · Fine series · Tap drill, clearance hole, torque, strength and tool sizes — every number on one page.
Tap drill (75% thread)
60 mm
No standard inch drill this large · Clearance hole (normal fit): 70 mm ·
8.8 torque: 15873 N·m dry
Thread dimensions
Major diameter
64 mm
Pitch
4 mm
TPI (equivalent)
6.35
Pitch diameter
61.402 mm
Minor diameter
59.67 mm
Tensile stress area
2850.79 mm²
Tap drill sizes for M64×4
Percent of thread is a trade-off: 75% is the shop default because the last 25% of engagement adds only a few percent of strength while roughly doubling tapping torque. Drop to 50–65% in tough or gummy material, or for blind holes where a snapped tap means scrapping the part.
| Thread engagement | Exact | Metric drill | Nearest inch drill |
|---|---|---|---|
| 50% | 61.402 mm | 61.5 mm | no standard inch drill |
| 65% | 60.622 mm | 60.5 mm | no standard inch drill |
| 75% | 60.103 mm | 60 mm | no standard inch drill |
| 85% | 59.583 mm | 59.5 mm | no standard inch drill |
Roll (form) taps need a larger hole than cut taps — add roughly
0.4× the pitch to the 75% cut-tap drill and confirm against your tap maker's chart.
Clearance hole for M64×4
| Fit | Hole | Use |
|---|---|---|
| Close | 66 mm | Located joints, dowel-like alignment |
| Normal | 70 mm | General assembly — use this unless you have a reason not to |
| Loose | 74 mm | Weldments, sheet stacks, tolerance build-up |
M64×4 torque specs
Calculated with the short-form equation T = K · D · F, using K = 0.2 (plain, dry, as-received steel) and a target clamp load of 75% of proof load — the standard preload target for a reusable joint.
| Grade | Dry | Lubricated | Dry (lb-ft) | Clamp load |
|---|---|---|---|---|
| 4.6 Low-carbon steel, general purpose | 6158 N·m | 4618 N·m | 4542 lb-ft | 481.1 kN |
| 8.8 Medium-carbon, quenched & tempered — the default structural grade | 15873 N·m | 11905 N·m | 11707 lb-ft | 1240.1 kN |
| 10.9 Alloy steel, Q&T — high strength | 22715 N·m | 17036 N·m | 16754 lb-ft | 1774.6 kN |
| 12.9 Alloy steel, Q&T — highest common grade (socket head cap screws) | 26547 N·m | 19910 N·m | 19580 lb-ft | 2073.9 kN |
| A2-70 304 stainless, cold worked | 12315 N·m | 9237 N·m | 9083 lb-ft | 962.1 kN |
The nut factor K dominates this result. Zinc-plated, waxed, anti-seize
and lubricated threads all shift K between roughly 0.10 and 0.25, which is a 2.5×
spread in torque for identical preload. If preload actually matters, torque-to-yield,
angle control or a load-indicating washer beats a torque wrench every time.
Tool sizes
Hex head wrench
95 mm
Hex key (socket head)
46 mm