Home › M60×4
M60×4 — Full Fastener Spec
ISO 68-1 / ISO 261 · Fine series · Tap drill, clearance hole, torque, strength and tool sizes — every number on one page.
Tap drill (75% thread)
56 mm
No standard inch drill this large · Clearance hole (normal fit): 66 mm ·
8.8 torque: 12971 N·m dry
Thread dimensions
Major diameter
60 mm
Pitch
4 mm
TPI (equivalent)
6.35
Pitch diameter
57.402 mm
Minor diameter
55.67 mm
Tensile stress area
2484.81 mm²
Tap drill sizes for M60×4
Percent of thread is a trade-off: 75% is the shop default because the last 25% of engagement adds only a few percent of strength while roughly doubling tapping torque. Drop to 50–65% in tough or gummy material, or for blind holes where a snapped tap means scrapping the part.
| Thread engagement | Exact | Metric drill | Nearest inch drill |
|---|---|---|---|
| 50% | 57.402 mm | 57.5 mm | no standard inch drill |
| 65% | 56.622 mm | 56.5 mm | no standard inch drill |
| 75% | 56.103 mm | 56 mm | no standard inch drill |
| 85% | 55.583 mm | 55.5 mm | no standard inch drill |
Roll (form) taps need a larger hole than cut taps — add roughly
0.4× the pitch to the 75% cut-tap drill and confirm against your tap maker's chart.
Clearance hole for M60×4
| Fit | Hole | Use |
|---|---|---|
| Close | 62 mm | Located joints, dowel-like alignment |
| Normal | 66 mm | General assembly — use this unless you have a reason not to |
| Loose | 70 mm | Weldments, sheet stacks, tolerance build-up |
M60×4 torque specs
Calculated with the short-form equation T = K · D · F, using K = 0.2 (plain, dry, as-received steel) and a target clamp load of 75% of proof load — the standard preload target for a reusable joint.
| Grade | Dry | Lubricated | Dry (lb-ft) | Clamp load |
|---|---|---|---|---|
| 4.6 Low-carbon steel, general purpose | 5032 N·m | 3774 N·m | 3711 lb-ft | 419.3 kN |
| 8.8 Medium-carbon, quenched & tempered — the default structural grade | 12971 N·m | 9728 N·m | 9567 lb-ft | 1080.9 kN |
| 10.9 Alloy steel, Q&T — high strength | 18562 N·m | 13921 N·m | 13690 lb-ft | 1546.8 kN |
| 12.9 Alloy steel, Q&T — highest common grade (socket head cap screws) | 21692 N·m | 16269 N·m | 15999 lb-ft | 1807.7 kN |
| A2-70 304 stainless, cold worked | 10063 N·m | 7548 N·m | 7422 lb-ft | 838.6 kN |
The nut factor K dominates this result. Zinc-plated, waxed, anti-seize
and lubricated threads all shift K between roughly 0.10 and 0.25, which is a 2.5×
spread in torque for identical preload. If preload actually matters, torque-to-yield,
angle control or a load-indicating washer beats a torque wrench every time.
Tool sizes
Hex head wrench
90 mm
Hex key (socket head)
41 mm