Home › #6-32 UNC
#6-32 UNC — Full Fastener Spec
ASME B1.1 (Unified) · Unc series · Tap drill, clearance hole, torque, strength and tool sizes — every number on one page.
Tap drill (75% thread)
#36 (0.1065")
2.7 mm · Clearance hole (normal fit): 0.1700" (#18) ·
Grade 5 torque: 1.33 lb-ft dry
Thread dimensions
Major diameter
0.138 "
Threads per inch
32
Pitch
0.794 mm
Pitch diameter
0.1177 "
Minor diameter
0.1042 "
Tensile stress area
0.00909 in²
Tap drill sizes for #6-32 UNC
Percent of thread is a trade-off: 75% is the shop default because the last 25% of engagement adds only a few percent of strength while roughly doubling tapping torque. Drop to 50–65% in tough or gummy material, or for blind holes where a snapped tap means scrapping the part.
| Thread engagement | Exact | Inch drill | Nearest metric drill |
|---|---|---|---|
| 50% | 0.1177" | #32 (0.1160") | 3 mm |
| 65% | 0.1116" | #34 (0.1110") | 2.8 mm |
| 75% | 0.1076" | #36 (0.1065") | 2.7 mm |
| 85% | 0.1035" | #37 (0.1040") | 2.6 mm |
Roll (form) taps need a larger hole than cut taps — add roughly
0.4× the pitch to the 75% cut-tap drill and confirm against your tap maker's chart.
Clearance hole for #6-32 UNC
| Fit | Drill | Use |
|---|---|---|
| Close | 0.1540" (#23) | Located joints, dowel-like alignment |
| Normal | 0.1700" (#18) | General assembly — use this unless you have a reason not to |
| Loose | 0.1850" (#13) | Weldments, sheet stacks, tolerance build-up |
#6-32 UNC torque specs
Calculated with the short-form equation T = K · D · F, using K = 0.2 (plain, dry, as-received steel) and a target clamp load of 75% of proof load — the standard preload target for a reusable joint.
| Grade | Dry | Lubricated | Dry (N·m) | Clamp load |
|---|---|---|---|---|
| Grade 2 Low/medium carbon steel, unmarked head | 0.862 lb-ft | 0.646 lb-ft | 1.17 N·m | 374 lb |
| Grade 5 Medium carbon Q&T, 3 radial head marks | 1.33 lb-ft | 0.999 lb-ft | 1.81 N·m | 579 lb |
| Grade 8 Medium carbon alloy Q&T, 6 radial head marks | 1.88 lb-ft | 1.41 lb-ft | 2.55 N·m | 817 lb |
| 18-8 SS 304/18-8 stainless | 0.627 lb-ft | 0.47 lb-ft | 0.85 N·m | 272 lb |
The nut factor K dominates this result. Zinc-plated, waxed, anti-seize
and lubricated threads all shift K between roughly 0.10 and 0.25, which is a 2.5×
spread in torque for identical preload. If preload actually matters, torque-to-yield,
angle control or a load-indicating washer beats a torque wrench every time.
Tool sizes
Hex head wrench
5/16"
Hex key (socket head)
7/64